Glass has sophisticated front properties and are used as facades in high buildings. During cold periods, these glass facades could cause thermal discomfort, due to cold downdraught. Cold downdraught can be countered by placing heaters under glass surfaces. Nowadays technology offers highly insulating windows, which is why there is an interest to investigate the indoor climate with only underfloor heating. The research in this area is limited, and few empirical methods are available.

AbstractThe indoor environment affects the human performance. Noise pollution, poor lightning and coloring are some of the factors that affect our work performance. The human is also affected by the air change and temperature, these factors are in most buildings possible to adjust and through this make economic savings. To find out about the indoor environment in the O-building a questionnaire was handed out, measurements/surveys and an interview was also made. 108 questionnaires where handed out to employees and students.

A large amount of our time is spent indoors in an artificial climate. To make the experience pleasant there are requirements on the ventilation and the heating system. At the present time the most common form of heating is a radiator system complemented with a ventilation system. A ceiling heating system with combined heating and ventilation can replace the two separated systems. The benefit with a ceiling heating solution is that it saves space since the radiator system is no longer needed.

Indoor Energy is a company that works in the energy sector. It works through itsthree subsidiaries Indoor Energy Services, Indoor Energy Control and Indoor EnergyConsultants. Because of their comprehensive experience and offering of broad rangeof services they can contribute to integrated extensive solutions for their customers.Indoor Energy Control works with building management through control andregulation. This work is realigned by programmers and project managers. Working inthis area is complex and places a great demand on both technical innovation andprofessional project management.Due to the complexity of the work Indoor Energy Control has a hard time to get thenew employees to be independent in their work as a programmer.

The starting point for this master thesis was the product of the company "Humlegården", which allows its tenants in office buildings to follow their electricity consumption in real time, through their Smartphone's. The idea that resulted from that application is to investigate if it is possible to direct the tenants in office buildings to reduce their energy consumptions, but also to be satisfied with the indoor environment. This work addresses the factors which are the main energy consumers in office buildings. It addresses legal requirements and standards which are important to follow in order to achieve good thermal comfort in buildings. Some of them are physical climate factors like thermal environment, air quality and lightning.

VAV (Variable Air Volume) system has been studied in a newly constructed office-building. The goal for the study has been to evaluate how the ventilations system work in practice, if adjustments can be made to achieve an more energy efficient system and to evaluate if other alternative ventilation systems is to be preferred in the further.The degree project has been executed at Helenius Engineering Firm who is working with the environment, media systems, HVAC and energy in buildings. The building that has been studied is owned and operated by Akademiska hus.Literature studies, visits at site, inventory, review of system documentation, energy analyses, interviews, key figures, LCC, sand energy- and indoor climate simulations has been made to study the building. Where appropriate some tools from Six Sigma have also been used.How to achieve an energy efficient system and a pleasant indoor climate is studied with human health and well-being as base for the indoor climate requirements. Technical support systems such as ventilation systems have to be designed so that an acceptable indoor climate can be achieved.

There are many different recommendations on how to keep pelargoniums over winter, but most of the recommendations suggest ?the higher the temperature, the more light and water the pelargonium needs?. The purpose with this paper is to try to explain the best and the worst results that are achieved with different storage alternatives of zonal pelargoniums. The results are based on an orientating investigation carried out in January-February, and a questionnaire that members of the Swedish Pelargonium Society answered to. Both the orientating investigation and the questionnaire showed that zonal pelargoniums are best stored light and cold but frost free. They should be irrigated according to their needs which is when the soil is dry, about every second to third week. Zonal pelargoniums are very resistant to drought and can survive without water for at least 44 days, both when kept under light and cold as well as under light and warm.

The control of Indoor temperature must be able to handle large time constants and both measureable disturbances like outdoor temperature, and non-measurable disturbances, like waste heat from appliances. Due to cheaper microcontrollers (small computers with designated tasks) with better performance, more advanced and computation-demanding methods for control can be used.In this thesis, Generalized Predictive Control (GPC) has been implemented and tested on a theoretically derived model of a house. GPC states that a model of the system is estimated in every sample, and the control is carried out simultaneously, based on predictions of the model. Disturbances like solar radiation can be estimated and used in the control as well. The control signals are determined by quadratic programming, which makes it possible to consider conditions, for example limitations on the control signals.GPC requires a number of parameters to be defined, like model order and control signal penalty, but is relatively robust for variations in them.

AbstractIn urban societies people spend more and more time indoors, which put great demands on the indoor environment. If the ventilation is to manage the removal of unwanted substances in the indoor air, a good mixing of the air is required. The question arises that, whether the buoyancy forces will counteract a good mixing of the indoor air or not?This report aims to clear up the difficulties whether you need to consider the buoyancy forces or not, when adjusting a ventilation unit. For studying the indoor mixing of the air a two dimensional model is constructed in COMSOL Multiphysics.

In this final thesis a rough description of aluminium extrusion is made, the importance of temperature of both the raw material and the extruded profile for a good profile quality. The difficulty in controlling these temperatures are discussed and attempts to increase the control are described. The attempts are basically made by controlling the furnace that is heating the raw material. This is done in a manner that the raw material reaches its final temperature shortly before it is extruded. An IR-camera at the press can be used for profile temperature measurements.

This report describes an investigation of the indoor climate in two different workspaces. Since we a big part of our lives are staying indoors in artificial environments, and more particularly in our workplaces, we think it would be interesting to do this investigation. The technical solutions for air treatment systems began with simple natural systems without fans and where the thermal rise of the air applied. In modern time is technical air treating systems used to take care of the fresh air supply. This type of units can supply filtered air with the right temperature to the building. Well-functioning ventilation is essential to bring clean fresh air to the room and effectively remove impurities without sound- or draught problems. The indoor climate is relevant for the output capacity.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.

Cooling down the indoor air can be done in several ways. One way is desiccantcooling which will be used at the Stockholm Arena. This method is used in airhandling units that use temperature changes and moisture fluctuations in the air. Oneof the steps is to add heat during the cooling process in order to reduce the relativehumidity of the exhaust air. The air passes thru an adsorptions rotor which thenabsorbs moisture from the supply air.

The aim of the present study was to evaluate the effects of large amounts of straw in the farrowing pen on thermal regulation of the newborn piglet in different weight classes. 20 sows were given 15 kg of straw in the farrowing pen 2 days prior to until 7 days after parturition. A control group of 18 sows had no straw in the pen. 6 litters from each treatment were observed. Measurements of piglet body temperature were made at 0h, 2h, 4h, 8h and 24h after parturition. At ?8h? the body temperature of the piglets in the Straw group were significantly higher (P=0,0149) than the piglets in the Control group.

Climate and environmental issues is now high on the agenda. We live in a generation that must try to solve some major environmental problems. Buildings and habitations account for approximately 40 % of Sweden's total energy today. To reduce this figure, as needed, more research in the field of energy efficiency is required.This thesis concerns the heating of buildings. The load on district heating is heavy during certain times of the day.